Note:
Make sure the PC’s network port is enabled with DHCP client.
3. Insert a paper clip into the reset switch. Press and hold the reset button before applying
power to the ONA.
4. Connect the cable from the network switch to the Network side of the ONA for PoE power. If
PoE power is unavailable, connect an external power adapter.
5. Continue pressing and holding the reset button until the Status LED cycles through a steady
red/green/blue. Then release the reset button and the Status LED flashes a steady amber,
which indicates that the Manual Configuration menu is running.
Note:
After this step, wait for a few seconds so that the PC gets an IP address for the ONA
over DHCP.
6. On the PC, use a browser to connect to the ONA configuration menu with the address http://
192.168.100.1.
Note:
You cannot go directly to this web page. You must complete steps 1–5 first.
7. Click
Upgrade Software
.
8. Select the software upgrade package that you want to upload.
9. Click
Send
to upload the image to the ONA. This may take up to five minutes.
Note:
Do not refresh or close the webpage during the upgrade.
10. Click
Return to Configuration page
.
11. Click
Reboot into Operational Mode
.
12. Disconnect the PC.
Upgrading a deployed ONA
See the
Avaya Open Networking Adapter 1101GT Release Notes
(NN48800-400) for the latest
information on upgrading ONA software on a deployed service.
May 2016
Avaya Open Networking Adapter 1101GT Installation Job Aid
13