Avanzini DRAGO D1/M, Instruction, Use And Maintenance Manual

Page: 44 / 104

CHAPTER 5
Instructions, use and maintenance manual
Page 44
5.6. OPERATIONS ON OVEN INSTALLATIONS
This paragraph describes the physical characteristics and setting up procedures of the oven where the machine
will be installed.
The procedure described below can be followed in order to convert a conventional wood-burning oven into an
oven equipped with gas burner.
5.6.1. HOLE IN THE COOKING TOP
The Drago burner is installed in the surface of the oven; the extensions of the torches have to pass through the
oven base, until they reach the level of the cooking surface.
his is done by means of drilling a special hole with diameter of mm and positioned at mm from the inside
wall of the oven.
In the following layout, you can see the area of proper positioning of the hole.
A
C
B
IDEAL POSITION OF THE
HOLE
A mm
B mm
C mm
he recommended position I I I I s.r.l. is the side part, either left or right, at a distance of
mm from the central axis; nonetheless, you can position the burner anywhere in the area marked off with a red
dotted line.
The company AVANZINI BRUCIATORI s.r.l. does not authorise any type of installation other than the indicated
layout.
he c stomer is solely responsible for ma ing s re the final installation is in compliance with the re irements
in force.
CAUTION!
he machine, having to be sed inside a prod ction plant, is not e ipped with its own fire
prevention system. he ser m st eval ate the need for an ade ate fire prevention system for
the machine/site where the machine is installed and used.