8
INSTALLATION INSTRUCTIONS
?
Before Using Your Mini Kitchen
?
Remove the exterior and interior packing.
?
Check to be sure you have all of the following parts:
?
Drip/Baking Pan
?
Oven Wire Rack
?
Instruction Manual
?
Remove all the items inside your oven and clean the interior surface with lukewarm water using a
soft cloth.
?
Do not attempt to repair or replace any part of your oven unless it is specially recommended in
this manual.
?
This mini kitchen requires 1400W and should be the only appliance operating on the circuit.
?
Installation of Your Mini Kitchen
Select a location for the mini kitchen. The location should be in an open area on a flat counter where
the plug will reach an outlet.
?
When positioning the mini kitchen, it should be set on a flat, steady surface.
?
Do not block air vents. If they are blocked during operation, the oven may overheat and eventually
cause the mini kitchen failure.
?
Keep the mini kitchen away from hot air, steam or splashing liquids when choosing a place to locate
it, otherwise, the unit’s operation may be adversely affected, causing it to break down.
?
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
?
Plug the appliance into an exclusive properly installed wall outlet. Any questions concerning power
should be directed toward a certified electrician or an authorized Avanti Products service center.
?
Do not place anything on the top of the broiler oven and automatic toaster.
?
Keep the appliance at least 5 inches away from rear wall to ensure the proper ventilation.
?
Electrical Connection
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a
three-prong plug which mates with standard three prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
?
Warning
?
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized Avanti Products service center.
NOTICE
Before you use this oven for the first time
: The heating elements have a protective coating, which
must be burned off before use. To do this, open the oven door and set the temperature to 250
°
C /
480
°
F. Leave the appliance switched on for approximately 15 minutes. It is important to ensure
adequate ventilation during period.
The dual burners also have a protective coating, which must be burned off before use. To do this, set
the burner selector to the maximum setting 5 minutes. It is important to ensure adequate ventilation
during period. Switch off the burners and allow cooling completely.
Summary of Contents for TFL-11
Page 3: ...3...
