Site Hardware Preparation
.60
Avanti Installation Manual 2.0
12. CABLING
12.12 FITTING WEBRO WF125 COMPRESSION CONNECTORS
The WF125 cable uses the Cablecon/W
ebro 6.0
F connector; it has a center stinger already pre-fitted. The cable
must be prepared in the same manner. The centre core of the connector will come through confirming a good
connection internally.
1. Using stripping tool, insert cable and rotate
stripper around the cable several times until
cable is cut, then pull away. Discard pieces of
cable safely. Pull back all the braiding around
outer sheath of cable.
2. Fit
Cablecon/Webro
compression
connector
onto insertion tool and ensure a secure fit
using a 14mm spanner.
3. Place cable gripper on cable about 2cm
below cut part of cable.
TIP
Put a small amount of silicon grease into the rear of the connector around the neck of the center pillar, this will
lubricate the cable as you push it into the connector and will also provide additional waterproofing.
