17
Setting the set point (desired temperature value)
To display or change the set point, proceed as follow:
1. Press the “
Set
” button for more than 1 second to display the set point;
2. Increase or decrease the value of the set point, using the “ “ and “ “ respectively,
until reaching the desired value;
3. Press the “
Set
” button again to confirm the new value.
Alarms with manual reset
Alarms with manual reset can be reset by pressing the “ “ and “ “ “ for more than
5 seconds.
Manual defrost
As well as the automatic defrost function, a manual defrost can be enabled, if the
temperature conditions allow, by pressing the”
“
button for more than 5 seconds.
Continuous cycle
Pressing the buttons “ “ and “ “ simultaneously for more than 5 seconds enable
the continuous cycle function.
During operation in continuous cycle, the compressor continues to operate for the time “cc”
and it stops when reaches the “cc” time out or the minimum temperature envisaged (AL =
minimum temperature alarm threshold).
Continuous cycle setting: “cc” parameter (continuous cycle duration):”cc”=0 never
active;”c6” parameter (by passing the alarm after the continuous cycle):”cc” = 0 never
active; it avoid or delays the low temperature alarm after the continuous cycle.
Accessing the configuration parameter (type C)
1. Pressing the “ “ and “
Set”
buttons at the same time for more than 5 seconds, the
display will show “00”(password prompt).
2. Press “
Set
”
,
use the “ “ “ or “ “ buttons to display the number “22” (parameter
access password).
3. Confirm by pressing “
Set
”.
4. The display will show the first modifiable “C” parameter.
Accessing the configuration parameter (type F)
1. Hold the “ “ button for more than 5 seconds (if there are active alarms, first mute the
buzzer), the display will show the first modifiable “F” parameter.
Modifying the parameters
After having displayed the parameter, either type “C” or type “F”, proceed as follows:
1. Use the “ “ or “ “ buttons to scroll the parameters until the parameter to be
modified is reached. When scrolling the parameters, an icon is shown on the display that
represents the category of the parameter.
