User Manual
www.AvantcoEquipment.com 3
Assembly and
Installation
PLUNGER ASSEMBLY
1. Slide the
Plunger Seal
onto the
Plunger
(figure 1).
2. Assemble the
Pressure Release Valve Kit
onto the
Plunger
. From the top of the
Plunger, place the Washer onto the Valve
Hole, then insert the Screw through the
Washer and into the Valve Hole. From the
underside of the Plunger, place the Spring
onto the end of the Screw, then place the
Valve Cap onto the end of the Screw and
twist to secure.
3. Screw the Plunger Bolt onto the Plunger
Shaft (figure 2).
4. Place the assembled
Plunger
onto the end
of the
Plunger Shaft (figure 3).
STUFFER ASSEMBLY
5. Attached the
Handle
by sliding it onto
either the
Fast
or the
Slow Gear (figure 4).
6. Crank the
Handle
to bring the
Plunger
to
the top of the
Stuffer
.
...continued on next page
