Avantco Equipment 177DHC13, User Manual

Page: 6 / 19

User Manual
6 www.AvantcoEquipment.com
User Manual
6 www.AvantcoEquipment.com
User Manual
2 www.AvantcoEquipment.com
Index
Parts Overview .............................................................. 3
Standard Accessories .................................................... 4
Operation Instructions .................................................. 4
Figure 1: Gear Axle ........................................................ 5
Figure 2: Initiative Axle .................................................. 6
Figure 3: Fork ................................................................. 7
Figure 4: Change Speed Axle ........................................ 8
Figure 5: Turning Plate and Mixing Axle ....................... 9
Figure 6: Single Phase Motor Diagram ....................... 10
Figure 7: Center Axle ................................................... 11
Maintenance and Protection ........................................ 12
Troubleshooting ........................................................... 13
Warranty Information ................................................... 13
IMPORTANT SAFEGUARDS
1. When using electrical appliances, basic safety precautions should always be followed including the
following:
2. Read all instructions.
3. Close supervision is necessary when any appliance is used by or near children.
5. Avoid contacting moving parts.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is
dropped or damaged in any manner. Return appliance to the nearest authorized service facility for
examination, repair or electrical or mechanical adjustment.
injury.
8. Do not use outdoors
9. Keep hands, hair, clothing, as well as spatulas and other utensils away from beaters during operation to
reduce the risk of injury to persons, and/or damage to the mixer.
SAVE THESE INSTRUCTIONS
Cleaning
........................................................... 13
Operating Instructions
the machlnes wlth LCD offer the opportunlty to make a visual check to see
hen the product has reached the required temperature inside the bowl.
w
arnlng: during bowl and/or boller switch off the machine us-
To dispense hot chocolate proceed as follows;
place a cup beneath the tap;
use the lever on the tap (the product is dispensed when the lever is pressed
or pulled) until the required amount of product has been poured inside the
gradually release the tap lever so that it returns to the standby position (tap off).
cup;
ing the main swltch (LED off).
Warning: check to make sure that the water level never falla be-
low the minimum level, whlch is marked -MIN-; this will prevent
machine operations from being shut down.
- 115 V madel:
W
A level sensor wlll shut down machine operation as soon
as the water level falls below the minimum; to restore op-
eration, the boiler tank must be topped up. lf the machine
does not restart after the tank has been topped up, contact
a specialized technician.
Warning: never operate the machine without water in the boiler
as this would damage the heating element. a temperature sen-
sor will in any case cut out power to the heating element if there
is no water in the boiler. To restore the machine to normal op-
lf the product is especially thick, it is advisable to keep the rod
pulled out at the maximum position; any clogging in the dis-
pensino line may be removed by sliding the rod back and forth
while keeping the machine, as shown in the Fig. 12.
Warning: never touch the bowl or lid while the machine is oper-
ating, since they are very hot, Always use the knob when mov-
ing the bowl lid.
eration press the pushbutton underneath the base.
Warning: for correct machine operation, only use demineralized
water in the boiler tank.
SL320001846 E d.03 - 06/2008
Dispensing the product
It is advisable to keep the rod in the maximum dispensing posi-
tion to help the product to flow at the required rate.
- 9_EN -
04/2010
Dispensing the Product
Fig.11
WWW.AvantcoEquipment.com 6