17 (28)
WARNING
Risk of cutting and entanglement from contact with moving parts - Never leave the
equipment unattended while the engine is running.
The attachment may start
unexpectedly when removing a blockage, for example, if the hydraulic system is
pressurized. Always stop the attachment following the safe stopping procedure before
leaving the driver’s seat. Do not go near the attachment, if another person is operating
the controls of the loader. Shut down the loader engine and release the residual pressure
first.
.
6.1
Checks before use
Check that the trimmer and the cutting disc can rotate freely and that there is no string or other foreign
material around them.
Use only when all pins are locked and secured in place.
Ensure that bystanders are at a safe distance when operating the equipment. Do not let anyone to
enter danger area of the boom or to stay directly in front of the loader. Also make sure that it is safe to
reverse with the loader. Never assume that bystanders will remain where you last saw them;
especially children are often attracted to the moving equipment.
Check the general condition of the attachment and the loader, and check for possible hydraulic oil
leaks. The attachment must not be used, if there is a fault in the hydraulic system of the loader or the
attachment. Refer to Chapter 7 for maintenance instructions.
Operate the attachment and the controls of the loader only when seated on the driver’s seat. Ensure
that the loader and the attachment are used in a safe manner and as intended. Do not allow children
to operate the equipment.
Never operate the loader or attachments while under the influence of alcohol, drugs, medication that
may impair judgement or cause drowsiness, or if not otherwise medically fit to operate the equipment.
Remember correct working methods and avoid leaving the driver’s seat unnecessarily.Practise the
use of the attachment and the controls of the loader in a safe area. If you are unfamiliar with the
particular loader model, it is recommended to practice its use without any attachments.
WARNING
Hydraulic oil ejection hazard - Check that the mixer is properly mounted on either
side of the cutting disc.
Make sure that the hydraulic hoses are secured against contact
with moving parts.
.