35
500 Series
Operating instructions
Starting the engine
Before starting the engine do the daily checks, (see “Daily
inspections” on page 50). Adjust the seat and mirrors
(if fitted) so that you have a good working position and
unrestricted field of vision from the driver’s seat. Check
that all controls function correctly. Make sure that the
operating area is safe. Read and follow operating and
safety instructions.
Avoid unintended movements of
the attachment - Risk of injury to
bystanders.
If the auxiliary hydraulics
is switched on during starting and there
is a hydraulically operated attachment
on the machine, the attachment can
move suddenly and cause a dangerous
situation.
•
Make sure that the auxiliary
hydraulics control lever is in neutral
position during starting.
•
Do not actuate the auxiliary
hydraulics control buttons on the
joystick (if fitted) when starting.
Prevent unintended movements of
the loader.
Keep hands and feet away
from other controls of the loader while
starting.
Do not start the loader in enclosed
space - Exhaust emissions can kill
within minutes.
Exhaust emissions
are toxic in concentrated amounts.
Do not operate the loader in enclosed
spaces or insufficiently ventilated
spaces, i.e. open garage door first.
Engine block heater (option)
The loader can be equipped,
as an option, with an engine
block heater. The engine block
heater socket (220V-240V) is
on the right side in the rear of
the machine.
To start the engine
2
1
Do not actuate the starter for more than 10 seconds at a time. If the engine does not start, wait
for one minute before repeating attempt. If the engine does not start after a few attempts, or runs
poorly, see troubleshooting on page 59 and the engine owner’s manual.
After starting:
Allow the engine to warm up
and engine oil to circulate in
the engine for a moment before
loading the engine or increasing
engine revs.
Make sure that all the warning lights
on the control panel are off when the
engine is running. If the engine does
not start after a few attempts, or runs
poorly, See troubleshoot on page 59.
WARNING
WARNING
DANGER
NOTICE
NOTICE
NOTICE
1. Turn the battery disconnect switch to ON
2. Move the hand throttle lever to approximately ¼ throttle
3. Make sure that auxiliary hydraulics is switched off (lever in neutral
position). Do not press on the drive pedals.
4. Turn the ignition key to the right until the glow plug indicator light
turns on.
5. After the glow plug indicator light turns off, turn the ignition key
further to the right until the engine starts.
2
1
Summary of Contents for 500 Series 2019
Page 63: ... 63 500 Series Notes ...
