Avant Tecno Oy Avant 850, Operator'S Manual

Page: 39 / 138

Avant 850 Lift capacity
39
.
To estimate the load carrying capacity of the
loader
There are two representations of the tipping load in
this manual:

Load chart with pallet forks, including the table of
Rated Operating Capacity (ROC)

This information is also presented as a label
on the loader

Load diagram
Both of these show the same information about the
tipping load of the loader, but in a different way, and
with different details. The information in the load
diagram is more general, and can be applied to other
attachments as well to help you to avoid exceeding
the tipping load with any attachment.
Any illustration, chart, table, or value of tipping
load and the ROC table are valid only, when the
following conditions are met:

The ground is firm and level

Loader is stationary or driven slowly, max 2
km/h, with smooth and slow control
movements

Driver 75 kg is seated on the driver’s seat

Load is distributed evenly on pallet forks,
with the load centre of gravity at 500 mm
from the vertical part of pallet fork arms. The
weight of the fork attachment is taken into
account in the indicated load values
WARNING
All counterweights affect
stability - Also the driver. Always
lower the load on the ground
before leaving the driver's seat. If
the load is close to the tipping load
in the position and in the current
situation of the loader, the loader
could tip over as a result of leaving
the driver's seat.
.
Load charts of other attachments
In this manual there is only a load chart for the pallet
forks A36589. All Avant attachments have their own
operator's manual which include more information
about their rated operating capacities when used
with different loader models.
Always keep the manuals of all attachments
available for all operators of the loader. If you don't
have all manuals available, contact your Avant
dealer.
DANGER
Risk of getting crushed under
falling load - Never exceed
maximum load of the
attachment. The lifting force of the
loader and the tipping load may
exceed the maximum allowed load
of an attachment. The Rated
Operating Capacity in this manual
shows information for pallet forks
and it does not apply to other
attachments. Check the operator's
manual of the attachment and the
identification plate of the
attachment for information about
their maximum loads. Overloading
an attachment can cause damage
that becomes visible only later.