Avant Tecno Oy Avant 850, Operator'S Manual

Page: 20 / 138

Safety First Avant 850
20
Fire prevention
Clean the loader to avoid build-up of flammable
debris, such as dust, leaves, hay, straw, etc.

There are many parts of the diesel engine that
operate at high temperatures in normal use. To
avoid fire, and to ensure proper cooling, keep the
engine and engine bay clean. Overheating of the
engine or the hydraulic oil of the loader can
shorten their service life.

Do not smoke during refueling, or during any
inspection or maintenance work.

Add fuel and oils only at a well ventilated place.

Oil and fuel leaks can ignite on hot components.
Repair any damaged or leaking components
before using the loader. Refuel and add oil only
after the loader has been allowed to cool.

The battery of the loader can produce hydrogen
gas during recharge. This gas can cause fire or
even an explosion, if charging of the battery is
not made correctly. Charge battery in a well
ventilated place, and keep sources of ignition
away from battery during recharge. Static
electricity can produce sparks when removing
plastic covers, avoid handling or cleaning of
plastic covers when battery is connected to a
charger.
Know where fire extinguishing equipment is located
near your working site. At some areas a fire
extinguisher may be mandatory. Keep a multi-
purpose, approved type fire extinguisher available
near the place where you store the loader.
Fuses
There are several fuses located in different fuse
boxes on the loader. Always replace a blown fuse
only with a fuse with the same rating. For more
information about fuses see page 125.
.
Battery disconnect switch
The loader is equipped
with a battery
disconnect switch. The
switch is located at the
rear of the loader, on
the right side.
Always switch off the main current before you leave
the loader unattended, and before you do any
maintenance or inspections. Remove the key to
prevent unauthorized use.
Switching the battery disconnect switch to position
OFF (horizontal position of the switch key) will isolate
the battery from the electric system of loader, and
will prevent hazards related to damaged electric
wires, short-circuit, and overheat of electric
components. Some lights or devices of the loader
may remain powered after the engine has been
switched off. The small electric current will slowly
discharge the battery. Switching the main battery
switch to position OFF will also prevent this.
WARNING
Risk of fire - Always switch off
main current when the loader is
not used. Turn the battery
disconnect switch to position OFF
whenever leaving the loader
unattended or before servicing the
machine. If the switch is left to
position on, there is a risk of
sparks and short-circuit during
maintenance, and if any electric
insulator is damaged.