SID-15V
20 SID-15V Quick Reference Guide
2.2.3 Routing the Cables through the Base
FIG. 4C: CABLE ROUTING THROUGH STAND PASS-THROUGH
•
Route the cables through the pass-through hole along the backside of the unit and up
through the center hole that the Arm was taken out of.
NOTE: This pass-through hole should be lined with a plastic cable bushing to prevent cable
wear.
•
Gather the cables to the front of the hole, and insert the Arm back into the hole.
Please
use caution when doing this and make sure that no cables will be pinched between the
bottom of the Arm and the bottom base plate. The cables should run through the
pass-through along the back and hug around the arm up the top of the Bases hole
opening
.
•
Mount the Arm back onto the Base using the 3 screws that were removed earlier.
