Contact us for assistance: (866) 985-7877 | www.wtliving.com
4
AssemBlY
1
Locate one
A-Frame
Top
A
and one
Front Frame Leg
B
.
(HINT: the
Front Frame Legs
are slightly longer than the
Back
Frame Legs
.) Place the
A-Frame
Top
flat on the ground with the
90° angle to
the
left. Align the
Front Frame Leg
to the right side
of the
A-Frame
Top
as shown
. (Check orientation by
comparing the drilled holes to the inset drawing below right.)
Connect the pieces by fitting the Joint Bracket
E
over the joint
(matching the holes in the Joint Bracket with the holes in the
two frame pieces where they meet). Insert 2
Female
Screws
L
through the Joint Bracket and into the frame. Insert 2
Male
Screws
K
from the opposite side, as shown. Tighten
each
Male Screw into the corresponding Female Screw
using the
Hex Key
O
.
2
Finish assembling the first A-Frame by connecting the Back
Frame Leg
C
. Align the Back Frame Leg with the A-Frame Top
as shown. (Check orientation by comparing the drilled holes to
the inset drawing below right.)
Connect the pieces by fitting the Joint Bracket
E
over the joint
(matching the holes in the Joint Bracket with the holes in the
two frame pieces where they meet). Insert 2 Screws
L
through the Joint Bracket and into the frame. Insert 2 Screws
K
from the opposite side, as shown. Tighten hardware using the
Hex Key
O
.
A
B
L
K
Hardware Used:
K
Male
Screw (6x10mm) x 2
L
Female
Screw (
8x15
mm) x 2
Hardware Used:
K
Male
Screw (6x10mm) x 2
L
Female S
crew (
8x15
mm) x 2
The left A-Frame is now complete. Assemble the right A-
Frame by following the same steps described above, but be
sure to place the Joint Brackets on the opposite side of the
joints (the Joint Brackets on each A-Frame should face
outwards, AWAY from the shelves supported by the A-
Frames.)
Hardware Used:
K
Male S
crew (6x10mm) x
4
L
Female S
crew (7x48mm) x
4
E
L
K
E
C
