5.2 Rear Panel
Part1: IR Channel
IR EXT:
if the panel sensor is obstructed or the unit is installed in a closed area out of infrared line
of sight, the IR RX receiver included can be inserted into the IR EXT port at the rear to extend the
IR sensor range and enable local control of the matrix.
IR IN/OUT:
Super IR control system interface. for further details, please refer to the Super IR
system control introduction.
Part2: VGA CV AND AUDIO INPUT
Connect to the VGA or CV input source devices such as a DVD player, a Set-top Box or PC with
VGA cable or RCA
coaxial
cable.Each VGA or CV input is accompanied with a 3.5mm stereo audio
input.
Part 3: PC CONTROL
TCP/IP:
This port is the link for TCP/IP controls, connect to an active Ethernet link with an RJ45
terminated cable.
RS232:
Connect to a PC or control system with D-Sub 9-pin cable for the transmission of RS-232
commands.
Part4: OUTPUT
The HDMI OUTPUT connect to HDMI equipped TVs.
Part5: HDMI INPUT
Connect to the HDMI input source devices such as a DVD player or a Set-top Box with HDMI
cable.
Part6: DC POWER INPUT
Plug the 12V/2.5A DC power supply into the DC12V power in.
6. Remote Control
(1).
Press this button to power on the matrix or set it to standby mode.
(2).RESET Button: Press this button reset to the factory settings
(3).Output selection and Picture adjust a. Letters correspond with the outputs
on the matrix.
b. Press the button to adjust the output picture. For example: Press output
1>SCALER, the output 1 video will be scaler adjust.
Note: The AUTO ADJUST button only work on VGA input.
(4).Input selection and Sources input selection:
a. Numbers correspond with the inputs on the matrix.
b. Press the button to select source input. For example: Press input 1>VGA,
The input 1 will be select the VGA video input.
(5).Mode selection: Select switch mode; matrix, multi-viewer and video wall,
and in multi-viewer mode, press buttons IN/M1, IN/M2, IN/M3, IN/M4 select
