26
To activate Group Bypass II press key ‘0’ three times. To activate both group bypass
groups, press 0 then 88.
When Group Bypass is selected, the buzzer and LEDs react as follows:
The Shunt LED stops blinking 8 seconds after Arming, (prevents LED light from
disturbing sleepers near the keypad)
There is no exit/entry delay-warning buzzer, and keys beep at the keypad.
No ‘beeps’ at the keypad until an alarm occurs, or until Group Bypass is canceled.
When the keypads LEDs are turned off after Arming (requires programming),
touching the keypad will turn them on for 5 seconds.
6.3 Key Zero Hold-Down functions
1.
0
Shunt
Key 0
Concise Alarm History
: Hold down key ‘0’ to display the last alarm
sequence.
2.
0
Shunt
and
0
Shunt
Detailed Events History (requires programming):
Hold
down key ‘0’ and again hold down key ‘0’ to display up to 36 events, including: System
opening and closing by user number, opening or closing time, alarming zone and AC fail.
By holding-down key
0
Shunt
twice, 3 LEDs start blinking, to indicate a special operation
mode. The events are displayed from the most recent event to the oldest.
3. To silent local keypad buzzer hold down key "0" and #, to activate the buzzer repeat
the 0 and #.
Event
AV-707, 706 display
Time set
xx Time Set
Date set
xx Date Set
Installer programming
xx Installer Prg
User programming
xx User Program
Factory defaults
xx Fctry. Default
Communication (to CS) failure
xx Comm. Failure
Panic from Panic zone
xx PANIC
Keypad locked (code error)
xx Keypad Locked
Low Battery
xx Low Battery
Table 1: Events as displayed at series 4000