29
If this happens...
Cause
Try this solution...
The device turns on,but does
not generate electric pulses.
Intensity goes to “0”.
The device doesn’t turn on
even though new batteries
are installed.
1.Lead wires or electrode pads
are broken or disconnected.
2.Treatment time expired.
System is not set-up properly
or resistance to pads is not
detected by device.
1. Replace/reconnect lead wires.
2.Ensure lead wires are properly
seated in CH1/CH2.
3.Switch the device to the OFF
position and then power ON.
The intensity will go to “0” if any
of adjustment on any parameters
are changed, such as change on
time, waveform, frequency, pulse
width,etc.
Contact our customer service
at
