Electronic Volume Control
Music Equalizer
Radio Operations
- This unit uses an electronic volume control.
- To increase or decrease the loudness of this unit, press the volume up Vol + or volume down Vol - keys.
- Release the key when volume level is at the desired loudness.
- Sometimes, especially during listening to the radio, you may notice a "click-click-click" sound when you
are increasing or decreasing the volume. This is a normal condition and the sound will disappear when
you release the volume key (when you reach the desired volume level).
- Press the EQ key repeatedly to choose the desired sound effect according to the music you are
listening to:
*Pass Classic Rock Pop Jazz
*Pass means equalizer is "Bypassed" or "Off".
- Press the On/Off button once to switch “On” the unit.
- Press the Tuner button to select the desired radio band.
- For AM stations, rotate or reposition the set to improve radio reception.
- For FM stations, extend and adjust the telescopic antenna to obtain the best reception.
- Use the FM Mono/Stereo button to select the desired mode. In some cases, where reception is
poor, it may be advisable to select Mono Mode to improve clarity of the radio signal.
Manual Frequency Adjustment (Scan Mode)
- Press and immediately release the Next or Back button to scan (manually adjust) the radio stations
up or down by 1-step at a time.
- The radio digital display will indicate the exact station at each position.
- When a desired station is reached, it can be saved into one of the memory postions. See Radio
Memory section.
Automatic Frequency Adjustment (Seek Mode)
- Press and hold the Next or Back button for 2 seconds to seek (automatically adjust) the radio frequency
up or down to the next available radio station.
- The radio digital display will indicate the exact frequency of the next station that is found.
- When a desired station is reached, it can be saved into one of the memory positions. See Radio
Memory section.
Radio Memory (Station Preset Memory Storage)
- At any time the currently displayed station or frequency can be stored into one of the memory positions.
- Press the Program button once.
- Press the Mem. + or Mem. - button to select desired memory position. There are 10 memory positions for
AM band and 30 memory positions for the FM band.
- Press the Program button once to save the selected station into the selected memory position.
- To recall any saved memory press the Mem. + or Mem. - button, the saved radio-band will be recalled.
- To clear the memory of any position, simply save a new station to the same position.
10
