Installation and configuration
AutroSense Micra 10 Aspirating Smoke Detector Installers Handbook
27
Remote Control software
Provided free of charge with every detector, the
Remote Control
software
package enables the user to set up and configure the programmable functions of
one or more detectors or command module from a computer connected via an
RS
-232 serial cable. Complete instructions on how to install, launch, and use the
Remote
Control software is provided in
the Remote Control Software User Guide
under separate cover.
List of programmable functions
In the
Remote Control
program, the tabbed Functions Settings window contains
all of the available programmable functions.
For details about these functions
refer to the manual provided separately:
•
Remote Control Software User Guide
To change one of the programmable functions, go to the relevant tab, make the
change, and then click OK to save the changes to the detector’s internal
firmware.
The following
programmable functions are available:
•
Time and Date
•
Alarm Levels
•
Alarm Delays
•
ClassiFire Override (when optional Input/Relay card is installed)
•
Alarm Factor
•
LDD Enable
•
FastLearn Enable
•
Auto FastLearn Enable
•
ClassiFire 3D
•
Demo Mode
•
Day Start/Night Start
•
Disable Day/Night Switching
•
Remote Functions (when optional Input/Relay card is installed)
•
Programmed Isolate
•
Latching Alarms
•
Latching Faults
•
Cascading Alarms
•
Device Type (reference only)
•
Firmware Version
•
Run
-time Hours
•
Watchdog Count (reference only)
•
Device Text
•
Flow Rate (reference only)
•
Flow High Limit
•
Flow Low Limit
•
Flow Fault Delay
Summary of Contents for AutroSense Micra 10
Page 4: ...ii AutroSense Micra 10 Aspirating Smoke Detector Installers Handbook Glossary 45 Index 47...
Page 46: ...Troubleshooting 38 AutroSense Micra 10 Aspirating Smoke Detector Installers Handbook...
Page 52: ...Maintenance 44 AutroSense Micra 10 Aspirating Smoke Detector Installers Handbook...
Page 56: ......
