connection cable. The Code Reader cable is plugged into a
connector on the top of the Code Reader, and into a computer
interface connection in your vehicle.
1.
Locate the vehicle computer connection:
•
[OBD-II]
On OBD-II, the connector is usually located
under the drivers side of the dashboard. On some
vehicles, the connector is located behind the kick panels,
ashtray, or radio.
NOTE:
For additional connection location information, including
the “OBD Connector Locations Database,” please look at
the Customer Support page on the AutoXray web site
(www.autoxray.com ).
2.
Make sure that all the pins are straight and that the connecting
surfaces are free of oils, grease, and moisture.
CAUTION:
Do not force the cable connector into the Code
Reader or into the vehicle computer connection.
3.
Push the Code Reader cable and vehicle connectors
together firmly.
NOTE:
Make sure the Code Reader cable and vehicle connectors
are always properly seated during all test procedures.
4.
Insert the EZ-Read cable connector into the top of the Code Reader.
CONGRATULATIONS! The Code Reader is now set up,
connected, and ready to test your vehicle.
Page 46
S
ETUP
/ O
PERATING
I
NSTRUCTIONS
(C
ONT
.)
OBD-II Generic
Connector (Yellow)
This standardized cable is
used to scan 1996 and newer
Domestic, Asian, and
European vehicles.
Summary of Contents for EZ-READ
Page 1: ...USERS MANUAL EZ READ REVISION 2 1...
Page 36: ...Page 36 NOTES...
Page 37: ...Page 37 NOTES...
Page 64: ...Page 64...
