•
If your tank is not pre-filled, please follow the additional instructions below.
•
First, place the riser tube into the tank as shown in Figure 2.
NOTE: Please be
sure that the riser tube seats into the bottom of the tank, and that the top of
the riser tube is Approximately 1” above the top of the tank lip.
FIGURE 2
•
Before filling the tank, place a piece of duct tape over the top of the riser to
prevent resin from dropping down inside the riser tube as shown in Figure 3.
•
Place the included filling funnel over the top the the tank as shown in Figure 4,
and prepare to fill the tank.
If your softener system came with Gravel, please
pour this amount into the tank FIRST, then pour in the included resin media
afterwards.
FIGURE 3
FIGURE 4
•
Remove the filling funnel and duct tape and go on to the next section
© 1999-2007 QualityWaterForLess.com
- 3 -
