P. 4
Installation Guide
0
3 PIN CONNECTOR – 2 WIRE HARNESS
Wire Wire colour
Function
Description
1
BROWN
(–) Unlock output
Programmable 500mA negative output: 1/10-sec., 7/10-sec., 4-
sec. or double 1/4-sec. pulse (
ON
250 ms,
OFF
500 ms,
ON
250 ms)
2
No wire
(+) 12V
This pin pr12V output for INV-200 module
3
GREEN
(–) Lock output
Programmable 500mA negative output: 1/10-sec., 7/10-sec. or
4-sec. pulse
2 PURPLE WIRES
These wires serve as a starter kill. Cut the factory starter wire (from the vehicle) in half and connect the two cut
wires to the 14 AWG purple wires on the module.
How to Flash the Hood Pin
THE INSTALLER …
THE MODULE …
•
Press and hold the hood pin for 4 seconds.
•
Release the hood pin.
Parking Lights “ON”
•
While the parking lights are on, press down the hood pin once more
and release the hood pin immediately.
“ON” for 20 seconds
•
You now have 20 seconds to select one of the sub-menus
Programming a Transmitter
The transmitter does not come pre-programmed and must be programmed after the wiring of the module is
completed. The system can retain up to 4 different transmitter codes; if a fifth transmitter is programmed, the
code of the first transmitter in memory will be lost. To erase all transmitters from memory, perform a module
reset.
Proceed as follows to program a new transmitter:
1.
Flash the hood pin (see above) - the parking lights will stay on for up to 20 seconds.
2.
Before the lights go out, turn the ignition key to the
ON (RUN)
position
3.
When the lights are off, turn the key to the OFF position.
4.
Press and hold the
or
button until the parking lights flash 5 times quickly and the siren
chirps twice.
5.
The transmitter has been stored in memory.
6.
To exit: close the hood.
To program a transmitter on the second vehicle
for multi-car operation, you must press the
button
(instead of
or
) in step 4 of the transmitter programming procedure.
Programming Options
The system is equipped with two custom programming menus that allow the installer to custom-fit the outputs of
the system according to the requirements of each vehicle.
Proceed as follows to enter custom programming:
1.
Flash the hood pin switch (see above)
the parking lights will stay on for up to 20 seconds.
2.
Before the lights go out, press and hold the valet button and then press one of the following
buttons:
............................................to access mode 1;
............................................to access mode 2;
3.
The parking lights will flash and the horn will honk (if programmed) once or twice to confirm entry
into a mode.
4.
Release the valet button
