Installation Guide
P. 19
on some vehicles (such as BMW and certain Volkswagen vehicles), resetting will not work if the
brake pedal is pressed while the ignition key is
not
in the
I GNITION ON (RUN)
position: you will need
therefore to hot-wire the brake pedal by manually jumping 12 V with a fused test lead at the brake
pedal switch.
1.
Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 13 seconds to complete the next step.
2.
Press and release the Valet Button 6 times or more until the Parking Lights start to
flash.
3.
The
Parking Lights will flash 8 times
to confirm resetting.
Table 9: Resetting with the Valet Button
Events Logging
With this feature, the System will play back the last 4 Start Failure Events Codes and the
last Intrusion Code via the Parking Lights or L.E.D.
Events playback
Ensure that the Hood is up, that the vehicle is not in Valet Mode and that the Ignition is
OFF
.
•
Hold down the Hood Pin-switch for 4 seconds.
•
Release the Pin-switch.
The Parking Lights will come on.
•
While the Parking Lights are on, immediately push the Pin-switch 3 more times
(
down-up / down-up / down-up
).
The Parking Lights and L.E.D. will flash the five events stored in memory.
Table 10: Events playback
The first four playback codes are
start failure events
,
while the last playback code is an
intrusion
code
. There is a pause after each event code is played back. The system will play back the most
recent event first, then the sec ond one, and so on. if there is no event at all to report, the parking
lights will give one long flash. To jump directly the intrusion code, press the brake pedal. Close the
hood to end playback.
Start Failure Codes through the Parking Lights
1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach Cut-off
6 x = Hood
7 x = Engine Running, no Ignition detected,
or Tach before Start
10x = Alarm condition
Note
: “
x
” stands for one flash of the Parking Lights
Intrusion Codes
1 x = Power-up Reset: Battery
disconnected / reconnected or
dead…
2 x = Doors intrusion
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
Intrusion Codes through the LED Light
If there has been an intrusion in the vehicle while it was locked and armed, the LED will provide an
intrusion code matching the type of the intrusion which took place. The LED intrusion codes are
flashed in continuous loops, using the same codes as those provided during
Events Playback
: