P. 8
Installation
Guide
AS-1785
9
PURPLE
(–) External
Trigger
The External Trigger wire can be used for remote-
starting the vehicle with an external device. When
the vehicle is running, triggering this input will
activate Idle Mode. The External Trigger wire can
also be used to operate as a negative trigger with
the Trunk Pin-switch, the Key Sense wire or the
Door Pin-switch:
Option 1
Connects to Negative Trunk Pin. When
this wire is programmed for
TRUNK PIN
, pressing
TRUNK
will activate a 1-second
DISARM
output. If
ground (-) is detected on the
TRUNK
PIN (the Trunk
has been opened), an
ARM
pulse will be sent 5
seconds after the Trunk is closes. An
ARM
pulse
will be sent 4 seconds after the
TRUNK
button is
pressed if the Trunk pin state is unchanged (The
Trunk was unopened).
DISARM
is sent only if the
system was previously locked and armed. If Secure
Lock is enabled, UNLOCK pulse(s) will be sent with
DISARM
, a
LOCK
pulse and a
REARM
pulse will
be sent when the Trunk is closed or if the Trunk was
left closed.
Option 2
(Default: Engine Start/Stop): The first
Ground (-) pulse on this input will start the Engine,
the second Ground (-) pulse on this input will stop
the Engine.
Option 3
(Key Sense (-) Input): Connects to OEM
Key Sense Wire. When the Key is detected in the
Ignition Switch (Ground (-) signal on the OEM Key
Sense Wire) the Starter Kill will not
ARM
even when
it is set to Passive Mode. If Secure Lock is
programmed,
LOCK
and
ARM
will not be activated
while the Key Sense input is active (“active”
meaning there is a key in the Ignition barrel).
10
WHITE
(–) Ground Out
When Running
This wire provides a constant 500 mA ground output
while the Remote Car Starter is running. This output
becomes active at the same time as the Ignition and
shuts off when the Remote Car Starter shuts down,
e.g.: when the Run Time has expired, when the
STOP
button has been pressed, etc. This output
can be used to activate external relays, bypass kits,
etc..
