Autostart AS-1535 SH, Installation Manual

Page: 7 / 19

AS-1535 SH
Installation Guide
P.7
7
WHITE /
ORANGE
(–) Starter
Kill output
The unit is equipped with a selectable passive- or active-arming
Starter Kill circuit that will immobilize the vehicle when the system is
armed. This wire will provide a constant 500-mA negative output when
the system is
armed (locked by remote) or if remote started. This wire
should be connected to a Single Pole Double-Throw Relay (This wire
will connect to Pin 85, on the Relay, and Pin 86 will be connected to the
Ignition wire).
A second benefit of the Starter Kill is the Anti-Grind feature. When the
vehicle has been remote started the Anti-Grind prevents the starter
motor from re-engaging when the ignition key is inserted in the I
gnition
switch and accidentally turned to the
CRANK
position (The Starter Kill
output becomes active during remote starts).
8
ORANGE
(–) AUX 2
Output
Negative 500mA output. Can be programmed for one of the following
three options:
(1)
Constant while the
LOCK
and
UNLOCK
buttons are p 1 sec
after release of the buttons.
(2)
LOCK + UNLOCK
toggles
ON / OFF
. (Max.30 sec)
(3)
LOCK + UNLOCK
toggles
ON / OFF
. (Max.60 sec)
(4) Priority Door Access (2
nd
UNLOCK
press)
9
PURPLE
(-) External
Trigger
The External Trigger wire can be used for remote-starting the vehicle
with an external device. When the vehicle is running, triggering this
input will activate Idle Mode. The External Trigger wire can also be used
to operate as a negative trigger with the Trunk Pin-switch, the Key
Sense wire or the Door Pin-switch:
Option 1 Connects to Negative Trunk Pin. When this wire is
programmed for
TRUNK PIN
, pressing
TRUNK
will activate a 1-second
DISARM
output. If ground (-) is detected on the
TRUNK PIN
(the Trunk has
been opened), an
ARM
pulse will be sent 5 seconds after the Trunk is
closes. An
ARM
pulse will be sent 4 seconds after the
TRUNK
button is
pressed if the Trunk pin state is unchanged (The Trunk was unopened).
DISARM
is sent only if the system was previously locked and armed. If
Secure Lock is enabled,
UNLOCK
pulse(s) will be sent with
DISARM, a
LOCK
pulse and a
REARM
pulse will be sent when the Trunk is closed
or if the Trunk was left closed.
Option 2 (Default: Engine Start/Stop): The first Ground (-) pulse on
this input will start the Engine, the second Ground (-) pulse on this input
will stop the Engine.