6
·
Alerts receiving
If the remote control unit has got inputs to obtain information about the heater
operation, they can be connected to the RCP’s outputs Alert_1 and Alert_2. The
outputs have negative polarity. Therefore if remote control unit not fit it, it needs to
apply a matching circuit (with relay ex.).
Events given on the outputs Alert_1 and Alert_2 are adjusted by the settings 7.3 and
7.4 accordingly. Also the output line Timer_out can be used to send notification
how much time the heater operates.
·
Status output line application
1.
Indication of the heater operation by the hazard warning flashers (in addition
to the direction indicators in rear-view mirrors).
The module can indicate of the heater operation by hazard flashers. Connect the
module’s output X2.2 to the grey-red wire (pin 3 of the connector) of the hazard
warning switch, and choose the settings 7.5.3 (the settings 6.2-6.7 also need to
be adjusted) for this purpose.
3)
Installation procedure for permanent connection
·
General recommendations
The required tools: Torx screwdriver, wire cutter, wire stripper.
·
Remove the panel around the service connector on the left side of the
dashboard
·
Find place inside the dashboard to install the module (mounted on double-
sided tape)
·
Connect the module to car’s wiring according to the scheme at the fig.1.
Connect the module to the receiver unit of remote control, according to the
schemes at the figures 3-9. Make task specific connections, if necessary.
The module is powered and connected to the CAN-bus wires near the service
connector using quick splice connectors (supplied).
The module’s power (pin X1.9) connects to the orange wire of service connector
(pin 16), the module’s signal ground (pin X1.8) – to the black-white wire of service
connector (pin 4).
The signal «CAN-L» (pin X2.9) connects to the violet-orange wire (pin 11), the
signal «CAN-H» (pin X2.10) – to the grey-orange wire (pin 3). Twist brown and
brown-white wires of the connector X2 to the pair before connections. It is not
recommended to lengthen these wires.
