4
You can connect and use set of devices as a remote control of the fuel-fired heater:
specialized heater remotes (such as Telestart, EasyStart, Smart Start), additional
alarm systems remote controls, GSM mobile phones in conjunction with automotive
GSM-modules, etc.
If the remote control has output channels that give short impulses in active state, it
is possible to apply the schemes given at fig. 2-6. The remote control with two
independent channels can separately turn the heater on and off.
o
The fig.3 presents the scheme to turn the heater on by the impulse of
positive polarity. The fig.4 presents the scheme to turn the heater on by
the impulse of negative polarity.
Green
Blue
X1
3
4
to RC
RCP
Ground
X1
3
4
to RC
Green
Blue
RCP
Figure 2
Figure 3
o
The fig.4 presents the scheme to turn the heater off by the impulse of
positive polarity. The fig.5 presents the scheme to turn the heater on by
the impulse of negative polarity.
White
Grey
X1
1
2
to RC
RCP
Ground
X1
1
2
to RC
White
Grey
RCP
Figure 4
Figure 5
o
The remote control with the only one output line may be connected by the
scheme at fig. 6 to add a possibility not only to turn the heater on, but also
turn the heater off too. Every one impulse on the output line of the remote
control receiver unit will move the heater to the opposite state: switch on
idle heater, switch off operated heater. To realize this mode it is necessary
to connect in pairs the inputs He with Hea, and also the
inputs Heater_on- with Heater_off-.
