ColorMFA Manual, firmware v2.9.4_b31
25
Clear faults
If there is no need to pre-read the error codes, you can immediately erase all DTCs by
selecting the
"Clear Faults"
item. After erasing the DTCs from the memory of the selected ECU,
with a certain delay, the current status will be read and go to the error code display mode if they
remain after erasing (if DTC is permanent).
Messages
Messages (alarms and warnings) are displayed on the screen. In
the case of more than one message, you can view them one by one by
switching from one message to another with the
"Up"
and
"Down"
buttons.
The number of the current message and the total number are indicated
in the lower right corner of the screen.
If there are currently no messages, the screen shows "OK" and the
message "No messages".
System
Language
Selecting the interface language.
Only the interface language is selected, the following rules apply
when working with diagnostics:
- selected Russian - decoding of errors in Russian
- selected German - decoding errors in German
- selected Ukrainian - decoding of errors in Russian
- selected Spanish - decoding of errors in Spanish
- all other - decoding of errors in English
There are 16 languages supported in ColorMFA:
Russian, English, German, Bulgarian, Ukrainian, Spanish, Polish, Czech, Italian, Slovenian,
French, Dutch, Romanian, Lithuanian, Slovak, Portuguese.
