2013/05/29
RS-777 OP REV 1D
11
U. POWER SAVER MODE (Default OFF)
By table - 2 -1– 4 under Menu mode while “POWER SAVE” icon flash press
button, LCD HHU show
“
Save
” unit under power save mode, the LCD remote transceiver use “0” current to save the battery power, LCD
indicate “SAVE “.
Exit: Press any button of the LCD remote transmitter to exit “Power Save Mode”.
V. POWER ON MEMONRY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state if the
power is lost and then reconnected.
W. SECOND VEHICLE SECURITY OPERATION:
Your 1-way remote transmitter can be utilized to control a second vehicle security system, To program the remote
control transmitter to a second vehicle, follow the instructions
* For 1-way transmitter press button
+
for 2 seconds until transmitter LED
(flash 2 times )
a
s a shift button.
1. Once shift button (
+
)
is pressed the LED flash 2 times to indicate the second transmitter pin code has
built-in.
2. Press any button on the remote control transmitter to control a second vehicle security system LED on Transmitter
will flash 2 times indicate it’s 2
nd
car operation no matter which button is pressed.
** For LCD transceiver – 2
nd
car operation :
a. By table-2-1-6 Press and hold
F
button until 2 beeps heard, release
F
button
b.
flash on the text field of LCD screen, press
button to enter the menu mode.
c. Press & release
button to move down the menu to #6, CAR SELECT
d. Select CAR 1 or CAR 2 by pressing
or
button (text field show CAR 1 or CAR 2).
X. CHECK VEHICLE’S VOLTAGE:
Press and hold
F
button of LCD remote until
2
beeps sound , release and re-press
F
button for three times,
the LCD remote will show “VOLTS CHECK“ icon flash on text area (see Table
2
), then press
button to
activate system Voltage check. Please note that this data is for your reference only. Please check the
exact data on vehicle.
REMOTE START OPERATION:
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press
button once on the transmitter.
2. The parking light will activate to indicate the remote start received the signal.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking lights will turn on and the climate controls
will activate and adjust the vehicle’s interior temperature to your presetting. (While the vehicle is running,
the “minutes” digit on the LCD screen will flash and the will indicate count down timer based on the 5, 10,
20 or 30 minute run time set up by your installation center.)
5. The vehicle will run for a programmable 5 to 30 minute cycle before shutting down. (When the unit
shuts off the count down timer will turn off and the transmitter will play a melody.)
NOTE: The Remote Start Unit will not start the vehicle if any one of the following conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. The optional remote start enable toggle is switched to the “OFF” position. (If installed)
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”
SAFE START (Child safety mode)
Factory default is set to press the
button once on the transmitter to start the vehicle. You can program this feature
to eliminate an accidental remote start:
1. The user presses the transmitter
buttons twice within 3 seconds to start the vehicle. or
2. The user presses the transmitter
and
button at the same time to start the vehicle.
NOTE: Contact your installing dealer to activate this feature.
B. OPERATE THE VEHICLE WHILE RUNNING FROM THE REMOTE START:
To operate the vehicle while engine running from the remote start,
1. Insert the ignition key and turn it to “ON” (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.
C. TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the
motor running and the climate control on.
