Connect the positive clamp (+) to the battery positive (+) pole,
connect the negative clamp (-) to the battery negative (-) pole.
The charging value of charging depends on the type of
rechargeable battery, generally it’s about 10% of its maximum
current.
The charging time depends on the type of battery; in addition,
as the charging time grow more, the charging current will
decline to some extent.
This unit can be charged with one or more batteries at the
same time. When you charge the vehicle, the original battery
clamps should be removed.
•
•
•
10
•
11
When you start a high-powered engine, it is best to charge the
car battery for about 15 minutes and then start.
When start the diesel engine, the spark plug should be
preheated before starting.
When connect the clamps, connect the negative pole first and
then the positive pole.
•
•
•
Safety Note for Welding Machine Use
Please always keep good ventilation.
This is good for the
longer service life and working condition of the welder.The
EM325 welder is a small welder. While in operating, a large
working current is through. Natural ventilation cannot meet the
cooling requirements of the welder. A fan is installed to
effectively cool down the welder temperature to make it work
smoothly. The user should confirm that the ventilation is not
covered or blocked, and the surrounding objects should be
farther than 0.3 meters.
Overload prohibited.
The user should remember to observe
the maximum allowable load current (relatively selectable load
duration), keep the welding current not exceeding the
maximum allowed load current. The current overload will badly
shorten the life of the welder and may even burn the welding
machine.
•
•
EM325 welder has installed over-voltage, over-current and over-
heat protection circuits. When the grid voltage, output current
and internal temperature exceed the set standard, the welder will
stop working; furthermore, excessive use (such as excessive
voltage) will still cause damage to the welder, so you should still
pay attention to the following:
Note:
Turn off the power before removing the battery clamp.
Fireworks or flame are strictly prohibited at the operation site
as flammable gas will be generated during
charging.
Be careful to avoid rain, snow or moisture, as it will erode.
The po) and negative(-) poles must be distinguished
while using.
The machine should be protected from vibration or collision
while using.
Do not charge the battery that has ice on it.
Clean the rechargeable battery before charging to prevent
short circuits and detect the initial voltage.
•
•
•
•
•
•
•
Starting mode:
When you start the vehicle, there are some notes to be kept in
mind:
For starting the vehicle, press the button “Charge/ Start”to
“Start” to function.
•
•
