R-31
(A)
Photo
electric
sensor
(B)
Fiber
optic
sensor
(C)
Door/Area
sensor
(D)
Proximity
sensor
(E)
Pressure
sensor
(F)
Rotary
encoder
(G)
Connector/
Socket
(H)
Temp.
controller
(I)
SSR/
Power
controller
(J)
Counter
(K)
Timer
(L)
Panel
meter
(M)
Tacho/
Speed/ Pulse
meter
(N)
Display
unit
(O)
Sensor
controller
(P)
Switching
mode power
supply
(Q)
Stepper
motor&
Driver&Controller
(R)
Graphic/
Logic
panel
(S)
Field
network
device
(T)
Software
(U)
Other
GP/LP Common Features
24VDC
F.G.
+
+
-
-
Caution for using
Use communication cable after checking whether there is break, short.
Please install power switch or circuit-breaker in order to cut power supply off.
Separate this unit from high voltage line, power line to avoid inductive noise.
Do not use this product at below places.
Place where there is severe vibration or impact
Place where dust exists, or corrosion causing environments.
Place where strong magnetic field or electric noise are generated
Place where is temperature/humidity is beyond the specification
Place where strong alkalis or vibration or impact
Place where there are direct ray of the sun
Installation environment
It shall be used indoor.
Altitude Max. 2,000m
Pollution Degree 2
Installation Category
Ⅱ
Serial interface
● All devices connectable into LP-S044 including PC, PLC, serial printer, barcode reader and dedicated connectors can be
connected into both RS232C and RS422 ports.
● Device must be set for the port in system setting for LP-S044, LP-S070. For details, refer to "GP user manual".
● Use the dedicated communication cable for the each connected device.
(Refer to the "GP/LP communication cable" of R-32 page)
● For the method of wiring external devices of PLC, refer to "GP/LP communication manual".
Power wiring
● For power supply, use the wire of which cross section is at least 0.75mm² and
use the wire of which cross section is at least 1.25mm² for grounding.
● Use crimp-on type terminal with at least 3mm of internal diameter and less than
6mm of external diameter.
● Do not apply power before power line connection.
● Check power polarity.
● Tighten the terminal screw with 0.5 to 0.8N·m torque.
● Ground resistance should be less than 100Ω and ground it separately.
Battery replacement
Please contact out distributor to replace battery.
It may cause an explosion or a fire when improper battery is used.
Port
NO. Pin(GP-S044, GP-S057, GP-S070)
Pin(LP-S044, LP-S070)
RS232C
D-Sub 9Pin
Male
1
Non-used
Non-used
2
RXD
RXD
3
TXD
TXD
4
DTR
DTR
5
SG
SG
6
DSR
DSR
7
Non-used
Non-used
8
Non-used
Non-used
9
Non-used
Non-used
RS422
D-Sub 9Pin
Female
1
TXD+
TXD+
2
RXD+
RXD+
3
Non-used
Non-used
4
Non-used
Non-used
5
SG
SG
6
TXD-
TXD-
7
RXD-
RXD-
8
Non-used
Non-used
9
Non-used
Non-used
5
4
3
2
1
5
4
3
2
1
9
8
7
6
6
7
8
9
