J-41
Up/Down Counter/Timer
(A)
Photoelectric
Sensors
(B)
Fiber
Optic
Sensors
(C)
Door/Area
Sensors
(D)
Proximity
Sensors
(E)
Pressure
Sensors
(F)
Rotary
Encoders
(G)
Connectors/
Connector Cables/
Sensor Distribution
Boxes/Sockets
(H)
Temperature
Controllers
(I)
SSRs / Power
Controllers
(J)
Counters
(K)
Timers
(L)
Panel
Meters
(M)
Tacho /
Speed / Pulse
Meters
(N)
Display
Units
(O)
Sensor
Controllers
(P)
Switching
Mode Power
Supplies
(Q)
Stepper Motors
& Drivers
& Controllers
(R)
Graphic/
Logic
Panels
(S)
Field
Network
Devices
(T)
Software
Proper Usage
Dot for Decimal Point / Hour. Min. Second
● Follow instructions in ‘Proper Usage’. Otherwise, It may cause unexpected accidents.
● 24-48VDC, 24VAC power supply should be insulated and limited voltage/current or Class 2, SELV power supply device.
●
Use the product, 0.1 sec after supplying power.
● When supplying or turning off the power, use a switch or etc. to avoid chattering.
● Install a power switch or circuit breaker in the easily accessible place for supplying or disconnecting the power.
●
In case of contact input, set count speed to low speed mode (1cps or 30cps) to operate.
If set to high speed mode (2kcps or 5kcps), counting error occurs due to chattering.
●
Keep away from high voltage lines or power lines to prevent inductive noise.
In case installing power line and input signal line closely, use line filter or varistor at power line and shielded wire at input
signal line.
Do not use near the equipment which generates strong magnetic force or high frequency noise.
●
This product may be used in the following environments.
①
Indoors (in the environment condition rated in ‘Specifications’)
②
Altitude max. 2,000m
③
Pollution degree 2
④
Installation category II
※
In run mode, hold the
RESET
key for over 3 sec, and it
enters setting mode [
DP
].
※
In setting mode, hold the
RESET
key for over 3 sec, and it
saves the setting and returns to RUN mode.
※
If there is no
RESET
key input for 60 sec when entering
setting mode, it returns to RUN mode.
3 sec
3 sec
RUN mode
----
CLR
SET
Hour, Min, Sec are not divided
with dot.
E.g.)
5959
: 59 min 59 sec
Hour, Min, Sec are divided with dot.
E.g.)
)5(59
: 59 min 59 sec
Set decimal point
by front
RESET
Setting mode
Counter mode
Timer mode
DP
RESET
RESET
RESET
RESET
