Autonics ARD Series, User Manual

Page: 109 / 113

10 Parameter
© Copyright Reserved Autonics Co., Ltd. 109
10.1.6 Analog Input Point Object(0x0A)
Attribute
Name
Function
Command
Range Default
Service
code
Instance ID Attribute ID Data Type
Analog Data1
Value
Reading analog1 input value Get 1 to 4 0x03 UINT - -
Input Range
Setting
Input range setting
0: -10 to 10V
1: 0 to 5V
2: 0 to 10V
3: 4 to 20mA
6: -5 to 5V
7: 1 to 5V
8: 0 to 20mA
Get/Set 1 to 4 0x07 BYTE 0 to 8 1
Number of AD
Conversion
Points Setting
AD Conversion Point setting Get/Set 1 0x64 BYTE 1 to 4 4
Analog Data2
Value
Reading analog2 input value Get 1 to 4 0x65 UINT - -
Analog Status
Flag Read
Analog Status Flag
Bit 0:Low Alam(LL)
Bit 1:Low Warning(L)
Bit 2:Pass Signal
Bit 3:High Warning(H)
Bit 4:High Alam(HH)
Bit 5:Broken Wire
Bit 6:Under Range
Bit 7:Over Range
Get 1 to 4 0x66 BYTE - -
Analog Data1
Allocation
Selection
Analog Data1 allotment
Analog Input Value : 0
Peak value : 1
Bottom Value : 2
Get/Set 1 to 4 0x67 BYTE 0 to 2 0
Analog Data2
Allocation
Selection
Analog Data2 allotment
Analog Input Value : 0
Peak value : 1
Bottom Value : 2
Get/Set 1 to 4 0x68 BYTE 0 to 2 0
Function
Choice
Function setting
Bit 0 : Moving Average
Bit 1 : Scaling
Bit 2 : Peak/Bottom
Bit 3 : Comparator
Bit 4 : Adjustment Offset
Bit 5 : Adjustment Gradient
Bit 6 : Clear Max
Bit 7 : Clear Min
Get/Set 1 to 4 0x69 BYTE -
Bit0
Bit1
Scaling Type
Setting Default Scaling : 0
User Scaling : 1
Get/Set 1 to 4 0x6A BYTE 0 to 1 0