Using the Auto-Adjust
The FPM-180(-TS) will attempt to adjust itself to your computers current video model. If
the picture is stable, and centered vertically and horizontally the auto-adjustment is
complete. If however the picture is not stable, and centered vertically and horizontally
you can re-initate the auto adjustment. Once you have the unit displaying the resolution
you desire for your application, do the following:
Press HOLD and release the “Select” button on the membrane. This will place the unit
into a “Geometry Auto Adjust” mode. This operation will adjust the picture so it is
centered both vertically and horizontally on the LCD screen. It will also make the
necessary adjustments to the internal clock timing so that the picture is stable (without
any decernable pixel jitter).
After having completed this step you may wish to adjust the color balance. This
procedure adjusts for any imbalance in the Red, Green, and Blue levels from the video
cable or video card. This is accomplished using the LCDs OSD ( On Screen Menu)
system.
OSD (On Screen Display) Adjustments
There are four membrane buttons (see Fig 1, above) located on the rear of the unit.
They will activate the OSD and allow navigation to all adjustments the unit may require.
Press MENU key, OSD screen appears. [See Figure 2]
Press the UP/DOWN key to move between the five primary functions. (Indicated by highlighting)
Press the Select key when highlighting the Picture group to activate this sub-menu. You can now
navigate the sub-menu using the UP/DOWN keys. To make an adjustment to an item use the
buttons to make your adjustments
At anytime, press the Menu button two times to Exit and Save your settings.
This convention of Menu, Navigate, Select Sub Menu, Navigate, Select Item and Adjust item is
used throughout the OSD screen set up.
Press MENU key to return previous state and press MENU key twice to exit OSD.
