DPM1 User Manual, 1st Edition
User Manual - DPM1 Series Panel Meters
10
Programming Keys
ENTER
:
Enters configuration and
validates data and parameters.
UP:
Increases value of blinking digit in configuration
mode.
SHIFT:
Selects mode or shifts blinking digit in
configuration.
(Bottom View)
Configuration
When the power is applied to the meter, a display test begins automatically to check the function
of the LED’s and digits. Once this test is finished the display shows the internal software version
and then the unit goes to
RUN
mode.
Configuration follows a structure composed of a number of menus and submenus. By pressing
the
ENTER
key for <3 seconds, the main menu level is entered and the display will show “
Pro
”.
Pressing the
SHIFT
key provides access to the programming menu level which includes menus
for input configuration
(InP)
, display configuration
(dSP)
, relay configuration if present
(SEt)
,
analog output configuration if present
(A.out)
. Press
ENTER
to access the submenus under
each programming menu.
If configuration has been totally locked-out, when pressing
ENTER
to access the main menu
level, the display shows
dAtA
instead of
Pro
. This indicates that it is only possible to see
programmed information and that it is not allowed to modify any parameter from the entire
configuration. In this visualization mode, the meter automatically switches back to
RUN
mode
after 15 seconds from the last key press.
Run Mode
(¹) If parameter lock out has been enabled, dAtA will
be displayed instead of Pro
>3s
ec
<3s
ec
<3s
ec
>3s
ec
<3s
ec
In RUN mode
erases TARE
memory value.²
In RUN mode
sets display
value as new
TARE value.²
Enters configuration
menu (non-locked
out parameters).¹
Enters lock
out menu.
Displays detected maximum and
minimum values. Value RESET can
be done by pressing at least 3 sec.
(then new maximum or minimum
value is displayed).²
(²) Additional information provided later in this User Manual
The progress through the programming routines is done by pressing
ENTER
key. In general,
push
SHIFT
key a certain number of times to select an option and push
ENTER
key to validate
the change and move forward to the next step of the program.
