B&D Doors is a division of B&D Australia Pty Ltd
P: 13 62 63
W: www.bnd.com.au
Swing Gate Opener Set Up
DCB-05V2
Mount the Charger Board
a. Unplug the Control Box from mains power.
b. Remove the Control Box’s cover, then remove the transformer, EMC board (if fitted) and mains power
cable.
c. Mount the Charger Board inside the cover using four (4) M4x8 screws
11
.
d. Plug the Charger Board’s three wire harness (red/yellow/black) into the DCB-05 board’s “SBC-02” 5 pin
connector.
Connect the Solar Panel
a. Feed the Solar Panel’s
1
cable through black gland in the cover.
b. Connect the
red wire
to the Charger Board’s
3
“SOLAR+” connector, and the
black wire
to the
“-SOLAR” connector.
WARNING!
The opener will become active
during the following steps.
Mount & Connect the Battery
a. Drill a 16.0mm hole in the Battery Pack enclosure (recommend at the bottom) and fit nylon gland
9
.
b. Mount the Battery Pack
2
using the mounting lugs
6
and screws
7
close to the control box.
c. Feed the 2-core 18AWG gauge cable
8
through the Battery Box’s nylon gland
9
.
d. Connect the
red wire
to the Battery Box’s “+” terminal, and the
black wire
to the “–” terminal
e. Feed the other end of the 2-core 18AWG gauge cable
8
through the drive unit’s black grommet.
f. Connect the
red wire
to the Charger Board’s
3
“BAT+” connector, and the
black wire
to the “–BAT”
connector.
Setup and Test the Opener
a. Select Menu 7 on the DCB-05 control board, press “SET”, select Sub Menu 7 (“Battery/Solar”) and enable
using the “OPEN” and CLOSE” buttons.
b. Setup travel limits and transmitters as per the DCB-05V2 instruction manual.
c. Press either “OPEN” or “CLOSE” buttons, or use a transmitter to operate the gate.
d. Refit the Control Box’s cover.
WARNING!
Do not connect the batteries until
you have connected wiring on the charger board.
IMPORTANT WARNING!
Do not connect battery or solar panel
polarity incorrectly - this will result in
serious damage to components.
6
7
2
9
8
11
3
1
