6 - 8 Fiveways Boulevard, Keysborough, VIC, Australia 3173
P: 1300 133 944 E: [email protected]
W: www.automatictechnology.com.au
SOLAR
SHUNT
Mount the Charger Board
a. Unplug the drive unit from mains power.
b. Disengage motor using manual release cord.
c. Remove the main cover, timing cover and light diffuser, then remove the transformer, EMC board and
mains power cable.
d. Fix the Charger Board
3
under the timing cover using four (4) M4x8 screws
11
.
e. Feed the three wire cable attached to the Charger board
3
through the opening, then connect the
three wire harness (red/yellow/black) into the control board’s “SBC-02” 5 pin connector.
f. Plug the solar shunt
5
onto the control board’s “J13” connector.
Connect the Solar Panel
a. Feed the Solar Panel’s
1
cable through black grommet on the chassis.
b. Connect the
red wire
to the Charger Board’s
3
“SOLAR+” connector, and the
black wire
to the
“-SOLAR” connector.
WARNING!
The opener will become active
during the following steps.
Mount & Connect the Battery
a. Drill a 16.0mm hole in the Battery Pack enclosure (recommend at the bottom) and fit nylon gland
9
.
b. Mount the Battery Pack
2
using the mounting lugs
6
and screws
7
close to the opener.
c. Feed the 2-core 18AWG gauge cable
8
through the Battery Box’s nylon gland
9
.
d. Connect the
red wire
to the Battery Box’s “+” terminal, and the
black wire
to the “–” terminal
e. Feed the other end of the 2-core 18AWG gauge cable
8
through the drive unit’s black grommet.
f. Connect the
red wire
to the Charger Board’s
3
“BAT+” connector, and the
black wire
to the “–BAT”
connector.
g. Refit the timing cover, main cover and light diffuser.
Setup and Test the Opener
a. Setup travel limits and code transmitters as per the openers instruction manual.
b. Press either the Operate button on the opener or use a programmed transmitter to test the opener.
Roll Up Door Opener Set Up
GDO-6V4 EasyRoller
®
, RDO-1V3, RDO-1V4
IMPORTANT
WARNING!
Do not connect battery
or solar panel polarity
incorrectly - this will
result in serious damage
to components.
6
7
2
9
8
11
3
1
5
WARNING!
Do not connect the batteries until you have
connected wiring on the charger board.
