Automatic Technology SmartSolar KIT GEN 2 Manual Download Page 1

SMARTSOLAR

TM

 KIT GEN2

ITEM

DESCRIPTION

QTY

1

SOLAR PANEL - 30 WATT STP030-12/Lb

1

2

BATTERY PACK (2 X 12 Ah)

1

3

CHARGER BOARD (WITH HARNESS)

1

4

ACCESSORY PACK

1

SmartSolar

 Kit 

Solar Power Kits For Automatic Technology Openers 

1

2

3

4

ACCESSORY PACK 

ITEM

DESCRIPTION

QTY

5

2 PIN SOLAR SHUNT

1

GEWIS MOUNTING KIT (64805)

6

MOUNTING LUGS FOR GEWISS BOX

4

7

SCREW “P” M3.5 X 13

4

SOLAR BATTERY CABLE KIT (61821)

8

CABLE 2 CORE R&B X 1.0MM (2.5M)

1

9

NYLON GLAND M16-07B

1

SOLAR PACK 01 (61783)

10

PAN HEAD SCREW M4 X 8

4

SOLAR PACK 02 (61784)

11

TAPTITE SCREW “P” M4 X 8

4

SOLAR PACK 03 (61492) (GDO-8 ONLY)

12

BRUSH CARD 2047 L/F HARNESS

1

13

NYLON CABLE GLAND PGB7-07B

2

14

PAN HEAD SCREW M6 X 12

1

15

WASHER 6.4X20.6X1.2 GAL

1

16

WASHER RUBBER 1/16’X1”X3/8”

1

17

TIE MOUNT CM-13 (ADHEISIVE)

4

18

CABLE TIE 4” GT-100M

4

SOLAR PACK 04 (61786)

19

TAPTITE SCREW “P” M3 X 8

4

SOLAR PACK 05 (61787) (GDO-9 ONLY)

20

THRUSS SER HD SCREW “S” M4 X 8

2

21

TAPTITE SCREW “P” M4 X 8

3

22

PCB SUPPORT 76X27

1

Installing the Solar Panel

Unpack the Kit

Unpack the Battery Box and the Solar Panel and inspect them for any 

damage in transit.

Mount the Solar Panel

a.  Determine a mounting point for the solar panel as close as possible 

to the intended opener. The length of cable from solar panel to solar 

charger must not exceed 5m. 

b. The solar panel should be faced to the North for maximum effect. Solar 

panel output is directly proportional to the amount of sunlight to which 

it is exposed.  Thus, the panel should be positioned to the north due 

to Australia’s southern location.

c.  The angle to tilt the solar panel for maximum exposure to the sun is 

determined by the following equation:    

α

° = L° + 15°

Where “

α

°” is panel’s tilt angle from the horizontal, and “L°” is 

the latitude of the mounting location. Refer to table, for a list of  

pre-calculated panel angles for major centres in Australia.

α

°

TOWN

Latitude 

(L°)

Panel Angle 

(

α

°)

HOBART

42.5º S

57.5º

MELBOURNE

37.5º S

52.5º

CANBERRA, ADELAIDE, AlLBANY 

35º S

50º

SYDNEY

33.5º S

48.5º

NEWCASTLE, BROKEN HILL, PORT 

AUGUSTA, PERTH

32.5º S

47.5º

BRISBANE, OODNADATTA, 

GERALDTON

27.5º S

42.5º

TOWNSVILLE, TENNANT CREEK, 

PORT HEDLAND

20º S

35º

DARWIN

20º

Doc # 160035_03
Part #  13345
Released 18/10/16

Gen 2

Summary of Contents for SmartSolar KIT GEN 2









Reviews: