Owner Installation Instructions
NeoSlider™ - Sliding Gate Opener NES-24V1
33
RED
BLACK
RED
BLACK
RED
BLACK
YELLOW
R1=5.6K OHM
GREEN,BLUE,RED,GOLD
.25WATT 5% TOLERENCE
RESISTANCE
R1
YELLOW
BLACK
V- IN V+
P.E BEAM
57
fi g
57
fi g
56
fi g
+ -
+ -
+ -
24VDC
OUT
LIGHT
RELAY
LOCK
RELAY
V+ IN V-
P E BEAMS
CO
M
OPN
STP
CLS
OSC
SWP
PED
LIGHT RELAY MODULE
PULSE LOCK
COM
NO
LIGHT RELAY MODULE
POWER SUPPLY
NO
COM
ENGA
GED
3
+ -
+ -
+ -
24VDC
OUT
LIGHT
RELAY
LOCK
RELAY
V+ IN V-
P E BEAMS
CO
M
OPN
STP
CLS
OSC
SWP
PED
55
fi g
Accessories Installation
Photo Electric (PE) Beams
A photo electric (PE) Beams extends across the gate
opening. This photo electric (PE) Beams is designed to
detect an obstruction while the gate is closing and to
send a signal to the gate opener to reverse or stop
the
gate movement.
Fitting the PE Beams (optional)
Affi x the PE Beams in a strategic location within the
gateway. We recommend 150mm above the fl oor
level and as close as possible to the gate opening.
Connect the wires from the PE Beams wiring harness
to terminal block
(Fig. 55).
The wiring diagram is
for Model PE-2000TS (Order Code 61903).
Make sure that you are using the correct resistor i.e.
5k6 ohms (Green Blue Red Gold) and connecting
to number 2 (two) and 4 (four) terminal on the PE-
2000TS receiver. Make sure to align the beams
correctly. Follow the manual supplied with the PE
Beams.
Alignment
Power up the PE Beams. The green LED on the
transmitter and red LED on the receiver should turn
ON to indicate power is present.
If the receiver is connected to power and the red
LED is on while the green LED is on, the transmitter
and receiver are not aligned.
Make horizontal and/or vertical adjustment on the
transmitter and/or receiver until the red LED turns
off on the receiver, indicating alignment.
WARNING:
When using PE Beams, the gateway
must be clear of all obstructions and persons at
all times. The location of the beams and manner
in which it is installed might not give safety
protection at all times. Check to make sure that
the height of the beam and type used give
the maximum protection possible.
WARNING:
Install the PE Beams as per diagram in
(Fig. 55). Tampering with
PE Beams could result
in serious personal injury and/or property damage
and will void the warranty
.
Fitting solenoid or magnetic locks
Install the lock mechanism on the gate as per the
manufacturers instructions. The wiring diagram at right is
a representation of a typical lock with a bias for normally
closed contact
(Fig. 56)
.
Fitting courtesy lights
An AC or DC courtesy light can be activated via an
output on the gate opener control board. Connect the
light as per the diagram at right
(Fig. 57)
.
a.
b.
c.
a.
b.
c.
R1
