GDO-9 Enduro
TM
GEN2
Home Owners Manual
6
Fig. 4.1
Transmitter
•
To operate the opener, press the programmed
transmitter button until your door begins to move
(usually 2 seconds). Make sure you can see the
door when you use the transmitter.
•
If you are in a vehicle you should aim the
transmitter through your windscreen
(Fig. 4.1)
.
•
Check that the door is fully closed before you
drive away.
•
If you press the transmitter whilst the door is
moving the door will stop. The next press of the
transmitter will move the door in the opposite
direction.
The transmitter may also be programmed to operate
the following features (Refer to Section 8 for full
details):
•
Turn the courtesy light on and off without
operating the door,
•
Put the garage door opener into “Vacation Mode”
where it will not respond to any transmitters.
NOTE:
Additional transmitters may be purchased at
any time.
CAUTION:
Activate the opener only
when the door is in full view, free of
obstructions and with the opener
properly adjusted. No one should enter
or leave the garage while the door is in
motion. Do not allow children to play
with or near the door.
ELECTROCUTION!
This opener is a
mains voltage plug-in domestic appliance
and there are no user serviceable parts
inside this opener.
For maximum efficiency of your opener, your garage
door must be in good operating condition.
An annual service of your garage door by a Door
Professional is recommended.
4. Operating your door
