10
PROGRAM YOUR TRANSMITTERS (REMOTES)
To proceed to the next step you need to have programmed a remote control transmitter into the control board. To program a transmitter
press “P1” once on the control board and wait for the led “DL1” to light. Press the button (channel) on your remote control transmitter that
you wish to use for two seconds and release. Your transmitter should now be programmed. Repeat for other transmitters. You can also
program a second button (channel) on any transmitter to open in pedestrian mode. To program a transmitter to pedestrian opening press
“P1” twice and release (NB: Each press of P1 should be spaced by 1 second minimum), when “DL1” is lit press the button (channel) you
wish to use for pedestrian access. Up to 50 codes may be stored in any combination of full open or pedestrian open. To erase all codes
press and hold “P1” until the red LED “DL1” goes out (about 10 seconds)
IMPORTANT - (If you are not using transmitters you will need to connect a normally open momentary pushbutton into “COM” and “START”
terminals to proceed)
CHECK FOR CORRECT MOTOR DIRECTION
This is where you find out if you were lucky enough to have got your motor output wiring in the correct terminals. With your gear motor/s in
manual position them about half way open and lock them into automatic mode. Using the transmitter you programmed press the button
and release. Because this is the first activation after a power interruption your gates should open. Press your transmitter again to stop the
gates. To correct any leaf which did not open simply turn off the power, disconnect the battery lead and reverse the motor terminals. Apply
power and test again.
PROGRAM THE CONTROL BOARD
OPTION 1 - Automatic setting of the work times.
Use your transmitter and drive the gate/s to the fully open position. Set the trimmer RV1 to about half way. Press push button “P2” once for
a few seconds until “DL1” lights and release. After a few seconds the logic control will make some tests, and then it will self learn the
working time by closing the gate. The board will automatically exit this mode when complete and led “DL1” will go out. Use your transmitter
(or pushbutton) to test your installation.
OPTION 2 - Manual setting of the work times.
Use your transmitter and drive the gate/s to the fully closed position. Set the trimmer RV1 to about half way. Press push button “P2” once
and hold until “DL1” goes out (approx 10 seconds). After a few seconds the gate/s start opening at a reduced speed. During this phase use
trimmer “RV1” to obtain the desired slow down speed. When the gate reaches fully open press “P2” and release. Wait a few seconds for
“DL1” to light. Next press “P2” and release as follows to register the following steps.
Dual Gates (With Delay)
Single Gates or Dual Gates – No delay
Press 1 – Motor 1 Start
Press 1 – Motor 2 Start
Press 2 – Motor 2 Start (delayed)
Press 2 – Motor 2 Slow down start
Press 3 – Motor 1 Slow down start
Press 3 – Motor 2 Stop (Wait 5 seconds after hitting travel stop)
Press 4 – Motor 2 Slow down start
Press 5 – Motor 1 Stop (Wait 5 seconds after hitting travel stop)
Press 6 -- Motor 2 Stop (Wait 5 seconds after hitting travel stop)
The board will automatically exit this mode when complete and led “DL1” will go out. Use your transmitter (or pushbutton) to test your
installation.
Setting the pause time
Press push-button P3 until the led DL1 lights. Let the desired pause time pass, and then press push-button P3 again.
END OF SIMPLE SETUP
If all went well you have finished simple setup. On the following pages you will find some more detailed information and wiring diagrams to
enhance and add to your installation.
