5
50
0
© 2005 Directed Electronics—all rights reserved
and rearmed, and still allow NPC to bypass a faulty zone.
When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been
bypassed. (See
Diagnostics section of this guide.)
vvaalleett m
mooddee
TTo
o een
ntteerr o
orr eexxiitt vvaalleett m
mo
od
dee w
wiitth
h tth
hee vvaalleett//p
prro
og
grraam
m ssw
wiittcch
h::
1.
Turn the ignition key on and then off.
2.
At anytime during the next 10 seconds, press and release the Valet switch. Now the Status
LED will light constantly if you have entered Valet Mode, and go out if you have exited
Valet Mode.
TTo
o een
ntteerr o
orr eexxiitt vvaalleett m
mo
od
dee w
wiitth
h tth
hee ttrraan
nssm
miitttteerr::
To enter or exit Valet Mode with a transmitter:
1. Open any door.
2. Press
on the transmitter.
3. Press .
4. Press
again. You have now entered or exited Valet Mode (verify by checking your status LED).
rreeaarr ddeeffooggggeerr ccoonnttrrooll
The rear defogger output can be remotely turned on/off any time using the remote control. The default setting
is O
ON
N.
To turn the rear defogger output OFF:
1. Press & release the
and
and
buttons of the remote control.
2. The parking lights will flash 2-times.
3. The rear defogger output will no longer activate when the vehicle is remote started.
N
NO
OTTEE:: If the remote start is On the lights will turn off then flash 2-times before returning to
their normal output and the defogger output, if active, will cease.
