Autojack IG2200i, Safety And Operating Manual

Page: 14 / 36

IG2200i 12
OPERATION
6. Warm up the engine.
7.Turn the choke lever back to the
│ │
RUN
position.
8. Warm up the engine without a load for a few
minutes.
USING ELECTRIC POWER
1. AC APPLICATION
(a) Check the AC pilot lamp for proper voltage.
(b) Turn off the switch (es) of the electrical
appliance(s) before connecting to the generator.
(c) Insert the plug(s) of the electrical appliance(s)
into the receptacle.
CAUTION: Be sure the electric apparatus is
turned off before plugging in.
Be sure the total load is within generator rated
output.
Be sure the socket load current is within socket
rated current.
The economy control switch must be turned to
OFF when using electric devices that require a
large starting current, such as a compressor or
a sub
mersible
pump.
2
．
OVERLOAD INDICATOR LIGHT
The overload indicator light comes on when an
overload of a connected electrical device is
detected, the inverter unit overheats, or the AC
output voltage rises. The electronic breaker will
then activate, stopping power to the gener
ator
in
order to protect the generator and any connected
electric devices. The output pilot light (green) will
flicker and the overload indicator light (red) will
turn on, then the engine will stop running. If so
please follow the following steps:
(a)Turn off any connected electric devices and stop
the engine.
(b)Reduce the total wattage of connected electric
devices within the application range.
(c)Check for blockages in the cooling air inlet and
around the control unit. If any blockages are
found, remove.
(d)After checking, restart the engine.