Autojack IG1200i, Safety And Operating Manual, Page: 17 / 60

IG950i/IG1200i/IG2000i 15
Operation
Caution: Make sure that the appliance being
connected is in good working order if it begins
to act ab
normally or stops suddenly. Disconnect
it from the generator.
Caution: Make sure the appliance does not
exceed the maximum rated load for the
generato
r.
Caution: Any device which contains an
inductive load
e.g.
devices that contain a motor
may require more current on startup.
DC power
1.Set the economy control switch to ‘OFF’.
2.Start the generator.
3.Make sure the appliance is turned off before
connecting it to the generator.
4.Connect the 12V appliance (max 4A) to the
generator.
DC power (Topping up car batteries)
WARNING: For your safety perform the
following instructions in the order shown.
WARNING: You should only use this generator
to ‘Top up’ the battery, also trying to charge a
completely flat battery may cause the fuse to
blow.
1.Set the economy control switch to 'OFF'.
2.Start the generator.
3.Connect the battery charging leads to the
battery.
-Make sure you clamp the red wire to the
po) terminal and the black wire to the
negative (-) terminal of the battery
4.Connect the battery charging leads to the
generator.
-The battery will begin to charge.
5.Monitor the voltage across the battery regularly
during charging and disconnect the battery when
the voltage reaches 14.4 volts.
CAUTION: When disconnecting the battery,
always disconnect the negative lead first.
DC over load protector
If the DC overload protector activates, wait for a
few minutes and then press the reset button
shown on the right.