Autojack DP150, Original Instructions Manual

Page: 4 / 9

3
ADDITIONAL SAFETY INSTRUCTIONS
1. This tool is designed to be used as a polisher. Read all the warnings,instructions,indications
provided on drawings and specifications supplied with this tool. Failure to comply with all the
instructions provided may caused electrical shocks,fire and/or serious injuries.
2.
This tool is not intended to be used for something,mental brushing and cutting operations. The
use of this tool for unintended applications may cause hazards and injuries to people.
3.
The tool must be used with accessories that have been specifically designed or recommended
by the manufacturer. The fixing of the accessory to the tool does not guarantee a safe operation;read
the following additional instructions.
4.
The rated speed of the accessories must be at least equivalent to the maximum speed specified
on the tool. Using the accessories at speeds above the rated one,may cause them to break or be
projected into the air.
5.
The external diameter and thickness of the accessories must match the specifications of the
tooI. Accessories with incorrect dimensions cannot be adequately protected or controlled.
6. The configuration of accessories must match the tooI. The use of accessories that cannot be
perfectly fitted on the tool may result in imbalance,excessive vibrations and in the impossibility of
controlling the tool.
7.
Do not use damaged accessories.Before use,inspect all the accessories.Inspect the supporting
pads and verify there are no cracks,tears or excessive wear.If the tool or accessory has fallen,
verify that they are not damaged or install a new accessory .After inspecting or installing an
accessory
，
test the operation of the tool at maximum speed and without load for one
minute,keeping at a safety distance. IF the accessories are damaged,hey will break during this test.
8. Wear personal protective equipment.Depending on application,use face shield,safety goggles
or safety glasses.As appropriate,wear dust mask,hearing protectors,gloves and workshop apron
capable of stopping small abrasive or workpiece fragments.The eye protection must be capable
of stooping flying debris generated by various operations.
The dust mask or respirator must be
capable of filtrating particles generated by your operation.Prolonged exposure to high intensity noise may
cause hearing loss.
9.
Keep bystanders a safe distance away from work area.Anyone entering the work area must
wear personal protective equipment. Frag merits of workpiece or of a broken accessory may flu away
and cause injury beyond immediate area of operation.
10.
Hold power tool by insulated surfaces only,when performing an operation where the
cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a
"live”wire may make exposed metal parts of the power tool “live”and shock the operator.
11.Position the cord clear of the spinning accessory. If you lose control,the cord may be cut of
snagged and your hand or arm may be pulled into the spinning accessory.
12.Never lay the power tool down until the accessory has come to a complete stop. The spinning
accessory may grab the surface and pull the power tool out of your control.
13.Do not run the power tool while carrying it at your side. Accident contact with the spinning
accessory could snag your clothing,pulling the accessory into your body.
14.Regularly clean the power tool’s air vents. The motor's fan will draw the dust inside the housing and
excessive accumulation of powdered metal may cause electrical hazards.
15.Do not operate the power tool near flammable materials. Sparks could ignite these materials.
16.Do not use accessories that require liquid coolants. Using water or other liquid coolants may result