AutoGyro MTOsport, Maintenance Manual

Page: 135 / 191

Manufacturer
Maintenance Manual
AutoGyro
MTOsport
MMM-CV-E_16-06-13 Part E - 61-10-00 8-2 Page 1 of 3
61-10-00 8-2 RETROFIT: END POSITION DETECTION IVO PROPELLER OPR
GENERAL, REFERENCES AND REQUIREMENTS
Basic operational task, which can be performed by a licensed pilot or instructed personnel!
Secure gyroplane against unauthorized or unintended operation!
SPECIAL TOOLS AND CONSUMABLE MATERIALS
PRECAUTIONS AND SAFETY MEASURES
PROCEDURES
1
Contents of the kit (Fig. 1): 1) IVO-Control with pin assignment 2) 2 x Shrinking Hose to isolate unused
connectors 3) 2 x LED-Mount for 5mm Status LEDs 4) 3 x Cable Ties to fixate cables and installation 5)
Blind Plug to cover installation bore of removed thermo switch
2 Pin assignment of wiring harness - top to bottom (Fig. 2):
- red
- orange
- green
- black
- orange/white
- green/white
3 Remove all connectors from rocker switch (see Fig. 3)
Remove resistor pack (if installed) and discard
Remove thermo switch and close bore with blind plug.
4 The black ground cable has an extension with a second connector (see Fig. 4).
Isolate this second connector with the supplied shrinking hose. Sqeeze extending hot hose with pliers.
CAUTION: Do not push (or pull) at the LED cables. Use proper tools at LED socket.
5 Drill two 8mm holes right hand from the rocker switch (see Fig. 5).
Deburr holesInsert LEDs without mounting ring and fastening nut.
6 Fixate LED with mounting ring and nut from behind (see Fig. 6)
Insert LEDs in mount (use pliers, if needed). LED with cable color green goes in upper position, orange in
bottom position.
CAUTION: Do not mismatch electrical connectors as control board can be destroyed!
7 Connect cockpit controls to control board (see Fig. 7, note condensors facing up):
- white/orange (IVO)
- white/violett (IVO)
- black (GND)
- violett/orange (12V+)
8 Connect control board to rocker switch (Fig. 7):
- Switch/position '1a' (front): orange/white
- Switch/position '1' (middle): black
- Switch/position '1b' (aft): green/white
9
Check switching and indication logic (Master switch ‘ON’):
Press rocker switch
‘fine’ position
upper LED must blink, propeller must adjust to fine (take-off)
Press rocker switch ‘coarse’ position
lower LED must blink, propeller must adjust to coarse (cruise)
10 Fixate cables and control board with cable ties.
11 Perform functional check.