equipment det
ails
115
11.
C-200 CW only:
After use, open valve
blade (if still closed) and flush, lift the flush
handle and press it down (fig. 11). After
flushing, close the blade by turning the
blade handle.
11a.
C-200 CWE & CS only:
After use, open
valve blade (if still closed) and flush, press
the flush button (fig. 11a).
After flushing, close the blade by turning the
blade handle.
The waste holding tank is located underneath
the toilet and is removed for emptying from
the outside of the vehicle through an access
door. A rotating pour out spout, automatic
holding tank vent, air release valve, valve
blade, carrying handles and hand grip are
incorporated in the waste holding tank. A
sliding cover guarantees optimal hygiene.
Emptying the Holding Tank
The holding tank capacity is approx. 17 litres
and the tank should be emptied when the
waste-level indicator lights up. The waste-level
indicator lights up when the holding tank
contains more than 15 litres of waste.
CAUTIon: Do not allow the holding tank
to become overfilled. See trouble shooting
section for emergency emptying procedure.
12. Open access door and remove the holding
tank. The holding tank can only be removed
when the valve blade is closed (fig. 12).
13. Carry the holding tank to a normal
household type toilet or other authorised
disposal point. Place the holding tank in
vertical position and rotate pour out spout
upwards (fig. 13).
14. Remove the spout cap. Grasp unit by
upper carrying handle nearest to pour
out spout. Place other hand on upper
rear hand grip so that vent button can
be depressed with the thumb while
emptying. This ensures a smooth outflow
of the tank contents. (fig. 14).
Note: Only depress the vent button when
pour out spout is pointed downwards.
Rinse the holding tank with clean water. For
preparing for use again, see steps 1 to 7.
Cleaning and maintenance
The lipseal and the seal of the automatic vent
are made of rubber and therefore these parts
need regular maintenance (depending on
frequency of use, once or twice a month).
Lipseal:
Remove the sliding cover. Open the
valve-blade by turning the blade-opener knob
anticlockwise. Clean the seal with water. Dry
the seal and grease with silicone spray/oil or
vegetable oil.
Seal of automatic vent:
Turn the automatic
vent 60° anticlockwise and remove gently.
Clean the seal with water. Dry the seal and
grease with silicone spray/oil or vegetable oil.
Summary of Contents for 2012 Van Conversion Range
