Delete Existing Pairings
If stored pairings that are no longer needed on the Autocom Air or are faulty it is possible to delete them.
This will erase all pairings and all required devices must be repaired.
1.
Enter pairing mode on the Air unit (indicator LEDs flash RED and Blue alternately) then hold
down the
Multifunction Button (5) button for 10 seconds (Count 10 times RED LED flash).
2.
Pair with new mobile or navigation devices and your Air intercom unit.
Advanced Operation - Mobile Devices and Intercom Mode
1.
Adjusting Volume - Volume is adjusted with the + and - buttons (7) on the Air unit. Note that
media volume controls are available on your mobile device or satellite navigation system.
Maximum and minimum volume is indicated by an audible beep tone.
2.
Using a Navigation System - The Autocom Air is optimized for use with Garmin® satellite
navigation systems. After the navigation voice announcements have ended, the intercom will
automatically be reconnected if in use.
3.
Accepting and Ending Telephone Calls - One short press on the Multifunction Button (5)
accepts a call. End the call with one short press on the Multifunction Button (5) or wait until
your calling partner hangs up. Note, some mobile devices allow activation of automatic call
acceptance.
4.
Reject Telephone Call - Two short presses on Multifunction Button (5) will reject a call.
5.
Last Number Redial - To dial the last number called, two short presses of the Multifunction
Button (5) will dial out. Note, any other number will need to be entered into your mobile
device.
Summary of Contents for air
Page 2: ......
