Installation
1. Mount the dual sensors at the normal water level (with the water level
reaching the lower one) on the tank/sump with the magnet.
*
2. Connect one tube with the pump. Plug the siphon break into tubes, keep
it higher than the water level of the reservoir, and set up the water tube
by the universal holder.
3. Connect both of the DC pump and power adapter with the controller and
then connect power.
*Please avoid setting up the sensor in an area with micro bubbles.
2
Caution : Risk of Injury from Strong Magnets
Siphon break must be higher than the
water level in the reservoir.
Air In :
Siphon break allows air in to
break the siphon when the pump turns off.
Water Out :
Water drops out of the hole
are normal when the pump is on.
Air In
Water Out
Direction
Reservoir
Tank/Sump
DC Refill Pump
Power
Optical Level Sensor
English
