Spinflo S330 Hob
The Spinflo S330 is a fully recessed electronic
ignition 3 burner hob. The three burners are
fully adjustable from full flame to simmer.
Using the hob
Ensure that the gas cylinder valve is open and
that the isolation valve supplying the oven is
in the ‘ON’ position.
Important - The hob will support
200mm diameter pans on the outer
burners, and 180mm diameter pans
on the central burner. Avoid old or
misshapen pans as these may
cause instability.
The hinged glass lid must be fully opened prior
to using the hob.
To light
• Push the control knob of the desired burner
and rotate to the fully ‘ON’ position.
The pushing action will activate the
electronic ignition and the burner should
light. Keep the control knob pressed for
approximately 10-15 seconds, then release.
• If the burner has not lit within 15 seconds,
the control knob should be released and
the burner left for at least 1 minute before a
further attempt to ignite the burner is made.
• Adjust the control knob to the desired
cooking position.
To turn off
• Rotate the control knob until the line on the
knob is aligned with the ‘0’ on the hob facia.
Always make sure the control knob is in the
‘OFF’ position when you have finished using
the burner.
• Close the hinged glass lid.
Warning
The glass lid has a tendency to ‘snap’
shut towards the end of its lowering.
This is caused by the travel lock
action of the hinges as it is activated.
Make sure all fingers are removed
from the appliance when closing
the lid.
Spinflo S330 Hob
T A K E Y O U R S O N A N A D V E N T U R E
26
4188 AT Excel handbook 2011:Layout 1 23/11/10 14:26 Page 26
