24
auto-trail.co.uk
T H E
‘ N E X T G E N E R A T I O N ’
• Do not obstruct the gap at the bottom of the heater or the outlet
grille slots.
• Heaters should be switched off while the vehicle is in motion.
• A guard fitted around the heater is recommended where children
are present.
Note:
Inspect the exhaust duct and all connections at regular intervals,
and always in the event of blow back (misfire).
It is essential for the exhaust duct to be installed so that it slopes upwards
over its whole length and is secured with several clamps. Never place any
object on the exhaust duct, since this could result in damage. The exhaust
duct connection to both the heater and the cowl must be firm and well
sealed. It is no longer permissible to operate heaters with incorrectly fitted
or damaged exhaust ducts!
Never allow the warm air outlet on the heater to be obstructed in
any way.
For instance never hang washing on or in front of the heater to dry.
Misusing your heater in this way could cause serious damage from
overheating. Do not place flammable objects near the heater.
Please follow these guidelines in the interest of your own safety.
TRUMATIC C 3402/C 6002 VEHICLE HEATER
Operating Instructions
Check that any exterior flue covers are removed.
Turn on the gas cylinder and the isolation valve in the gas supply line.
Summer Operation (Hotwater Only)
Set the rotary switch (c) to summer operation 40°C or 60°C. Once the water
temperature has been reached (40°C or 60°C) the burner will switch off and
the yellow monitor lamp (g) will go out.
Winter Operation
Heating with hot water requirement:
Set the rotary switch (a) to the desired thermostat setting (1-9). When the
system is switched on, the green monitor light (b) will light up.
Set the rotary switch to the ‘operation’ setting (e).
Depending on the room temperature the heater will automatically select the
output of the heater required. Once the room temperature has been
reached, the burner switches back to the lowest stage and heats the water
content to 60°C. The yellow monitor lamp (g) indicates the heating up phase
is in progress, and goes out when the appropriate water temperature has
been reached.
Heating without hot water requirement:
Set the rotary switch (a) to the desired thermostat setting (1-9). When the
system is switched on, the green monitor light (b) will light up.
Set the rotary switch to the ‘operation’ setting (d)
TRUMATIC C 3402/C 6002 VEHICLE HEATER
A - Rotary switch for room temperature
B - Green ‘operation’ monitor lamp
C - Summer operation (water
temperature 40
°
C or 60
°
C)
D - Winter operation (heating without
hot water requirement)
E - Winter operation (heating with
hot water requirement)
F - Rotary ‘off’ switch
G - Yellow ‘boiler heating phase’
monitor lamp
H - Red ‘fault ‘ monitor lamp
A
G
H
B
C
F
D
E
Gas: Appliances
Gas: Appliances
7.